Reelcraft Cart Assembly - Manual (Page 2)

Cart Assembly
Page 2 www.reelcraft.com
APPLICATIONS
Reelcraft offers two hand cart models. Model 600741-1, has
semi-pneumatic wheels, and can be used with any 30000 series
hose reel with a 12” spool width. Model 600741-2, has semi-
pneumatic wheels, and can be used with any 30000 series hose
reel with a 12” spool width. These are ideal units for grounds
maintenance, farm and ranch, pressure wash, pest control, weld-
ing, industrial, air, and water applications.
ASSEMBLY
Before beginning any assembly, inspect packed materials for
shipping damage and completeness. Report any discrepancies
immediately.
1. As shown in figure 1, find handle (1) and locate 0.156 thru
hole near the bend in the handle. Attach two gripper clips
(5) to handle (1) using two self-tapping screws (6).
2. As shown in figure 2, attach legs (2) to handle (1) using
two hex cap screws (7) and two lock nuts (8). Set cart
height by choosing one of the four adjustment holes on
each leg.
3. As shown in figure 3, attach one universal axle (4) to each
leg (2) and secure using one locknut.
4. As shown in figure 4, add one wheel (3) to each axle (4)
and secure using one “E” retaining ring (10). Note: The “E”
retaining ring should be placed in the retaining ring groove
closest to the wheel.
5. As shown in figure 5, attach the reel to cart by placing the
reel on the cart and securing it with four hex cap screws
and four lock nuts. Make sure all bolted connections are
tight and secure.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5