Reelcraft Series D8000 Spring Driven Hose Reels (Enclosed Medium Pressure DxxxxEMP) - Manual

Operating Instructions
Series D8000 Spring Driven Hose Reels
Enclosed Medium Pressure Model Numbers:
Reelcraft Industries, Inc. • 2842 E Business Hwy 30, Columbia City, IN 46725
Ph: 800-444-3134 / 260-248-8188 • Fax: 800-444-4587 / 260-248-2605
Customer Service: 855-634-9109 • [email protected] • www.reelcraft.com
Form# 4808-84 Rev: 5/2013
D8640 EMP D8800 EMP D8840 EMP
D8650 EMP D8830 EMP D8850 EMP
Four 1/2” diameter mounting holes
Dimensions
A 21 5/8”
B 20 7/8”
C 7 7/8”
D 3 3/4”
E 10 1/2”
B
A
C
D
E
A
B
C
D
E
21 7/8"
20 7/8"
7 3/4"
3 3/4"
10 1/2"
1. Do not use reel at higher pressures or temperatures
than listed on the back of this bulletin.
2. Remove all spring tension before beginning
dissassembly process.
SAFETY
INSTALLATION: A flexible hose connection must be used between the hose reel inlet and the source of supply to prevent possible
misalignment and binding.
LUBRICATION: Hose reel spring and bearings are factory lubricated and require no further lubrication.
REPLACING HOSE: 1. Remove 1/4-20 hex nuts (4) which fasten the hose guide enclosure to the reel back cover, and pull off the
enclosure.
2. Wind spool flange clockwise-facing swivel-until spring is tight.
3. Back off two turns and latch.
4. Insert hose through roller guide.
5. Connect hose fitting to female outlet ell..
ADJUSTMENTS: To adjust spring tension, add or remove wraps of hose from the spool, one wrap at a time until desired tension is
obtained.
REPAIRS: Extensive repairs should be performed only by an authorized serviceman or factory to avoid damage which may
void your warranty. Remove all spring tension before beginning disassembly process.
MOUNTING: The hose reel is equipped with a universal mounting bracket so that it can be mounted on the floor, wall or
ceiling; whichever place is convenient. The hose guide arm can be moved to the position desired by removing the
1/4-20 hex nuts fastening the hose guide enclosure to the reel back cover. Shift the guide enclosure to the desired
position and replace the 1/4-20 hex nuts.
Caution: When changing guide arm positions, the U-bolt must
be placed in the proper location as instructed below. The reel
can “latch out” during use if this instruction is not adhered to.