Rapid-Air CABINET REEL WITH DISPLAY KEYPAD User Manual

Page 5

The next screen asks you to set the low set point. If the dancer arm is at “No Material
Rest” then just save the setting by pushing the Stop/Run Jog pushbutton.
_________________________________
| SENSOR LOW SETPOINT |
| SAVE XXX |
|_________________________________|

The next screen is for setting the high set point. Raise the dancer arm to its upper stop
position and press the save or Stop/Run /Jog button once.

_________________________________
| SENSOR HIGH SETPOINT |
| SAVE XXX |
|_________________________________|

The next screen is to set the offset of the program. Potentiometers are hard to get set from
left to right so we built in an offset. If you set the low and high range and go into run and
the reel runs for no reason then an offset has to put in. Go through the setup procedure again
and put in an offset of -3 to –5 and now the pot is zero.
_________________________________
| LOW OFFSET + 0 + |
| NEXT - |
|_________________________________|

You have now set the dancer arm limits. The next screen is to exit the setup and start work-
ing
_________________________________
| EXIT SETUP? YES |
| NO |
|_________________________________|

Choose yes and next and the next screen appears .