Rapid-Air SMART MINI-SERVO FEED CUT-TO-LENGTH: SMS2, SMS4, SMS8 - Manual (Page 13)

Programming Procedure
(continued)
EXIT
SET COUNTER VALUES
SET RESET
BATCh/ TOTAL
F1, set batch, on the “SET COUNTER
VALUES” screen leads to “BATCH
SET” screen discussed above in
SECTION 3.
F2, reset totals, on the “SET COUN-
TER VALUES” screen resets the total
counter to 000000.
F6, exit, will return to the “RAMP/
COUNTER” screen.
F2, speed/acc/dec, on the “RAMP/
COUNTER” screen leads to:
EXIT
ALTER PERCENTAGES
%ACC %DEC %SPEED
F6, exit, will return to the “RAMP/
COUNTER” screen.
F1, % acc, allows the acceleration
percentage to be altered with:
ENTER PERCENT OF ACC
MAX ACCEL = 000 %
MAXIMUM RATE (1 - 100) %
ENTER kEY TO EXIT
The enter key returns the display to
the “ALTER PERCENTAGES” screen.
F2, % dec, allows the deceleration
percentage to be altered with:
ENTER PERCENT OF DEC
MAX DECEL = 000 %
MAXIMUM RATE (1 - 100) %
ENTER kEY TO EXIT
The enter key returns the display to
the “ALTER PERCENTAGES” screen.
F3, % speed, allows the speed
percentage to be altered with:
ENTER PERCENT OF SPEED
MAX SPEED = 000 %
MAXIMUM RATE (1-100) %
ENTER kEY TO EXIT
The enter key returns the display to
the “ALTER PERCENTAGES” screen.
SECTION 4 F4 - JOB VALUES REVIEw
F4, job values, on the “MAIN MENU”
screen displays the following screen
until F6, exit, is pushed. This screen
lists the current active job number,
the feed length, the SPM, the per-
centage of speed, the percentage of
acceleration, and if a pilot is used.
JOB # 00 VALUES =
FEED LENGTh = 00.000
CUT = 000 % SPEED = 000
ACCEL = 000 F6 = EXIT
SECTION 5 F5 - RAMP/COUNTER
F5, ramp/counter, on the “MAIN
MENU” screen displays the following
screen:
EXIT
BATCh/ SPEED/
TOTAL ACC/DEC
F1, batch/total, on the
“RAMP/COUNTER” screen leads to: