Ramsey Winch HD-234 (JERR-DAN) {CURRENT} User Manual

Page 11

6. Check for signs of wear on gear teeth. If

replacement of gear is necessary, replace as
follows:

a) Press gear (item #8) from shaft (item

#12).

b) Examine shaft keys and keyways. If distor-

tion of keys and/or keyways is evident,
shaft and keys should be replaced.

c) Use a soft hammer to gently tap keys

(item #32) into keyways. Press gear (item
#8) over shaft and keys. Gear must be
centered over keys.

7. Remove seal (item #42) from back of (item

#10) gear housing. Press bushing (item
#16) from gear housing. Press new bushing
and seal back into place.

8. Check drum bushings (item #15) for signs

of wear. Replace if necessary by pressing old
bushings from drum. Press new ones into
place.

9. Examine shifter assembly (item #2) for

damage to yoke. Yoke should be firmly
attached to shaft, yet, able to swivel
freely around shaft. Replace if neces-
sary.

Install new shifter assembly (item #2)
by placing end of shaft, opposite yoke,
through spring (item #44) and into
housing (item #9).