Ramsey Winch JEEP GRILL GUARD/SPORT BAR KITS 293014 & 293015 User Manual

Page 4

Step 1 - Mount Solenoid to Winch

REP 6000/REP8000/REP9000

1. Attach band clamp to solenoid base as shown below.

2. Slide clamp over end of motor and position at 45° angle for clearance.

3. Tighten clamp until snug.

Step 2 - Vehicle Preparation

1. Remove tow hooks, if so equipped on vehicle – to re-install tow hooks, refer to Customizing your

Vehicle, Step 8.

2. Remove Front Stabilizer Mounting Bracket Bolts - Discard.

3. Remove four (4) Upper Bumper Mounting Bolts - Discard.

Step 3 - Mounting Plate Preparation

1. Attach Rubber Grommet (#4) as shown in Assembly Graphic (page 1) to Mounting Plate (#2).

2. Attach Roller Fairlead (furnished with Winch) to Mounting Plate using hardware furnished with

winch.

3. At this time mount Grille Guard (kit #251062), if purchased separately, to mounting plate as shown

in assembly graphic. Use (2) 5/16-18NCx3/4 Hex Head capscrews with lockwasher, each side
(#6,#7). Tighten hardware to proper torque (see chart page 2).