Ramsey Winch FORD QM KIT 251071 - Manual (Page 3)

1. Remove and discard the (2) factory
tow hook bolts from the tow hooks
on each side.
2. Remove tow hooks and set aside.
Removing the Tow Hooks
1. Notch metal bumper brace in center of
vehicle. Cutout should be 3” wide by
1/2” deep.
Installing the Frame Tube Assembly
2
1. Slide the frame tube assembly in
place from the back side of the
air dam.
2. Work the frame tube assembly in posi-
tion behind the transmission oil cooler
lines as shown in the photograph.
3. Install new 12mm x 1.75 bolt through
rear hole. Secure with 1/2” lockwash-
er and 1/2” flat washer. Tighten 2-3
turns only. Repeat for other side.
Installing the Frame Tube Assembly
3”
1/2”