Ramsey Winch JEEP WRANGLER KIT 295378 - Manual (Page 4)

4
9. Remove plastic trim piece below the grille and discard.
10. Run the 3/8” nut extenders (item #4) through upper holes on ends of
the frame.
11. Install mounting channel onto vehicle (rear mounting holes only) us-
ing two (2) 3/8” bolts (item #7), 3/8” lock washers (item #6), and
3/8” nut extenders (item #4). Tighten bolts. (See chart on page 5 for
proper torque values).
12. Bend end of the 3/8” nut extenders (item #4) downward.
TRIM PIECE
REAR MOUNTING HOLE