Ramsey Winch FORD WRAPAROUND KIT 295920 - Manual (Page 3)

KI-913352-0301-C 2
STEP 2
Secure lowest end of side plate assembly (item #6) to outside of lower R.H. & L.H. brackets (item
#11 & #12). Use (1) 3/8-16NC x 1-1/4 lg. hx.hd. capscrew (item #14) and nut (item #17), each side.
DO NOT TIGHTEN HARDWARE COMPLETELY. Pivot side plate assembly forward and place
channel (item #2), from behind side plate assembly, into place between R.H. and L.H. lower bracket
assemblies.
Pivot side plate assembly back into upright position. Place lower shims (item #24) between lower
brackets and side plates. Place shims (item #25) between end of channel and side plates. Align
mounting holes at ends of channel with holes in side plates, shims and lower bracket assemblies.
Use (2) 3/8-16NC x 1-1/4 lg. capscrews (item #14) and nuts (item #17), each side, to secure side
plate assembly and shim to channel and lower bracket assemblies, as shown.
Use (1) 1/2-13NC x 1-1/4 lg. hx.hd. capscrew (item #15) with 1/2" nut (item #18), each side, to
secure R.H. and L.H. strap assemblies (item #7 and #8) and upper shim (item #23) to inside of side
plate assembly (item #6) and R.H. and L.H. light guard assemblies (items #3 & #4) with shim (item
26). Use (4) 1/4-20NC x 3/4 lg. hx.hd. capscrews (item #13) with plastic washers (item #19) and
nuts (item #16), as shown, at remaining mounting holes to secure light guard assemblies (items #21
& #22) and shim (item 26) to side plates, each side.
DO NOT TIGHTEN HARDWARE COMPLETELY.
Place ends of tube assembly (item #5) into R.H. & L.H. light guard assemblies (item #3 & #4).
Squarely align kit with front of vehicle. TIGHTEN ALL HARDWARE TO PROPER TORQUE VALUE
(See Torque Value Chart, page 4).