Ramsey Winch DODGE QM KIT 251253 - Manual (Page 2)

2. Remove factory bolt assembly and reverse bolts so
they are pointing inward. When reversing bolt assem-
bly, insert flush with bumper bracket until Receiver
Assembly is installed.
2
1. Cut hole in air dam 3 1/4” wide x 3 1/2”
high. Hole should be centered over
length of air dam. Hint: Measure 1 5/8”
on either side of mounting clip at center
of air dam.
Height of hole will be from bottom of
top lip to top of bottom lip of air dam.
Do not cut through top or bottom lip.
Centerline
of Air Dam
Note: If the vehicle is equipped with a
diesel engine, raise hood and remove (2) bolts
on the radiator. It will be necessary to lift radia-
tor slightly to allow access to frame and
bumper bolt assemblies in the next steps.
If vehicle is not diesel, proceed to step #2.