Ramsey Winch CHEVY WRAPAROUND KIT 295361 - Manual (Page 3)

KI-913355 -0301-C 2
Step 3
Repeat Step 1 & Step 2 for right hand side of vehicle. Do not tighten hardware completely.
Step 4
Install lower tube assembly #6 between lower brackets #7 & #8.
Insert (1) shim #21 between tube and bracket at each end
(Figure 4). Secure using (1) 3/8-16NC x 1” plated capscrew
#12 through bracket and into threaded hole in each end of tube.
Do not tighten hardware completely.
Step 5
NOTE: YOU WILL NEED ASSISTANCE FOR THIS STEP.
Install left-hand side plate assembly #2. If you are mounting this kit on a Chevy Silverado, use the
bottom set of holes in the bracket assembly. If you are mounting this kit on a GMC Sierra, use the
top set of holes in the bracket (Figure 5). Insert (2) 3/8-16NC x 1-1/2” plated carriage bolts #10
through the holes in side plate #2 and into the appropriate holes in bracket #7. Have someone hold
the side plate in place while you position channel assembly #3. Secure using (1) black lockwasher
#18 and (1) black nut #15 for each carriage bolt. Do not tighten completely. Repeat for the right
hand side plate.
Step 6
Install upper tube assembly #5 between side plates #2.
Insert (1) shim #21 between tube and side plate at each end.
Secure using (1) 3/8-16NC x 1” plated capscrew #12 through
side plate and into threaded hole in each end of tube (Figure
6).
TIGHTEN ALL HARDWARE COMPLETELY. Start at the upper
tube assembly and work down to the lower bracket
assemblies tightening all hardware to the appropriate torque
value. (See Torque Value Chart on page 5).
Figure 4
Figure 5
Figure 6