Ramsey Winch REP 8000 12V MOTOR REPLACEMENT KIT 251283 - Manual

REP 8000 12V MOTOR REPLACEMENT KIT
#251283
This kit replaces an existing 12V permanent magnet motor on a Ramsey REP 8000 winch with a new series wound
motor. Refer to the parts list on page 4 for a complete list of items in this kit.
Before you begin, disconnect the solenoid battery leads from the battery and remove winch from mounting. Place
winch on flat work surface.
1. Disconnect motor leads and remove solenoid from motor and set
solenoid aside.
2. Remove tie bar bolts and tie bars from winch and set aside.
3. Lift motor end bearing from drum and discard. Install the
drum bushing (item #4) into the bore of the new motor
end bearing (item #1). Note: The drum bore has a cast-
in key which the split in the drum bushing must straddle.
4. Apply grease (Moreplex NLGI 2 or equivalent) sparingly to
the I.D. of the drum bushing.
913406-0806-A
RAMSEY WINCH COMPANY
PO BOX 581510 - TULSA OK 74158-1510
www.ramsey.com