Ramsey Winch LEVEL WINDER 2 L.H. 256110 - Manual (Page 2)

Engage the clutch and run the winch in the reel in direction winding about five wraps of cable onto
the drum and stop. Using a hammer tap these five wraps tightly over against the cable anchor
flange of the cable drum. Finish winding all the cable onto the cable drum. As cable winds onto the
drum, watch the tensioner. Tensioner must be free to move without obstruction to function
properly. If tensioner touches any surrounding structure, correct the problem.
CAUTION: STOP REEL IN OF CABLE BEFORE THIMBLE/HOOK ENTERS LEVEL WINDER.
FAILURE TO DO SO MAY CAUSE DAMAGE OR BREAKAGE TO THE WINCH, LEVEL
WINDER, OR VEHICLE.
OPERATION
Lay cable out in a straight line behind the truck to prevent kinking before beginning to wind in. It is
not necessary to walk in with the cable, let your Level Winder do the work.
PART
NO.
QTY. DESCRIPTION
414558 2 CAPSCREW 1/2-13NC X 3 LG. HX.HD. ALL THRD. GR. 5, PLTD.
418069 2 NUT-HEX. 1/2-13NC REG. PLTD.
418218 2 LOCKWASHER 1/2 MED. SECT. PLTD.
434254 1 DECAL
494115 2 SPRING, LH
688489 1 TENSIONER-CABLE
688524 1 RETAINER-SPRING, LH
RAMSEY WINCH COMPANY
P.O. BOX 581510
TULSA, OKLAHOMA 74158
KI-912598-1202-B
FIGURE 2
OVER CROSSBAR OF TENSIONER.
TANGS MUST SNAP INTO PLACE
HALF LOOPS ON ENDS OF SPRING
TENSIONER
TENSIONER. FAILURE TO DO SO
TENSIONER AND/OR VEHICLE
MAY CAUSE DAMAGE TO WINCH,
DO NOT ALLOW HOOK TO CONTACT
CAUTION
HOOK
SPRING RETAINER AND
MOUNTING HARDWARE
DRUM BARREL.
SECTION THRU CENTER OF DRUM
A-A
SHOWN ROTATED 90° CCW
SECTION
1.25 ±.50
RPH 8000
CLEAT
CABLE WRAPPED AROUND
BAR MUST NOT TOUCH
TENSIONER
15° (ON BARE DRUM)
NOTE: CABLE MUST FEED
BETWEEN CENTER CROSS
BAR AND FRONT CROSS BAR
OF LEVEL WINDER.