Ramsey Winch HD-P50000 W/TNR & 2 SPEED MOTOR - Manual (Page 3)

1
OM 914244-0511-D
Weight (without cable)...............................................742 lb. (337.27 Kgs.)
Rated Line Pull (lbs.).........................................................................50,000
18,960
6.6
41,800
Gear Reduction................................................................................51.35:1
dia. EIPS cable and 11.9 cu.in./Rev. motor.
* These specifications are based on recommended wire rope of .75 inch
(Kgs.)..............................................................................22,670
1 2 LAYER OF CABLE
*Line speed
*Cable capacity
(at 25 GPM)
per layer
*Rated line pull
FPM
Kg.
Lbs.
MPM
M.
Ft.
7 16
5.6
20 22
22,680
50,000
25 55
3 4 5 6
11,520
35
25,400
71
235
10.5
14,330
41
28
31,600
135
8.6
28
25
7.6
16,320
36,000
95
56
31
9.5
12,740
28,100
185
RAMSEY HYDRAULIC PLANETARY WINCH MODEL HD-P50,000
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and
safety procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until
you have carefully read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch
we make. If the need should arise, warranty procedure is outlined on the back of your self-addressed post-
age paid warranty card. Please read and fill out the enclosed warranty card and send it to Ramsey Winch
Company. If you have any problems with our winch, please follow instructions for prompt service on all war-
ranty claims. Refer to back page for limited warranty.
SPECIFICATIONS* (LOW SPEED MODE)
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope
ratings.
WARNINGS:
CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
CABLE ANCHOR IS NOT DESIGNED TO HOLD LOAD.