Ramsey Winch REP-8000 24V MOTOR REPLACEMENT 251277 - Manual (Page 2)

5. Install new motor end assembly (item #1) on drum aligning
motor shaft with brake coupling.
6. Reinstall tie bars using (2) 1/4-20UNC x 3/4” capscrews
(item #6) on the motor end. Tighten securely.
Set winch aside.
7. Remove cover from solenoid assembly.
8. Remove battery ground wire and set aside. Install motor lead
wire assembly (item #2) to same terminal.
Bend terminal lug up so that it does not touch solenoid base.
9. Remove solenoid ground wire and discard (see below left).
10. Install new solenoid ground wire (item #3) using existing
hardware. Route wire out the same hole as the battery lead
(see below right).
2
Battery
Ground
Wire
Battery
+ (Pos)
Wire
(RED)
Existing
Solenoid
Ground
Wire
New
Solenoid
Ground
wire