Ramsey Winch ATV REPLACEMENT MINI ROCKER SWITCH 256128 User Manual

Page 3

Solenoid Mounting: Choose a mounting
location that will remain protected and dry
(The best location will usually be where the
Solenoid for the Remote Switch was locat-
ed.) Solenoid must be mounted within 24” of
winch motor. Solenoid should be mounted
on a flat surface.

Installing the Solenoid

1. Use Solenoid Assembly as a guide to

mark and drill (2) 7/32” holes in location
determined for solenoid OR if there is no
good place to drill holes for mounting,
use the tube clamps (item #1-16).

2. Use (2) 3/4” long #10 screws (item #1-

5), (2) #10 flat washers (item #1-8),
and (2) #10 zinc locknuts (item #1-10)
to mount solenoid. Tighten to 60 in-lbs
(7 Nm) torque.

Installing the Rocker Switch

For clarification, see wiring schematic on
page 2.

1. Install green Wire Connector (item #1-

14) to green wire on Rocker Switch (item
#2) and black Wire Connector (item #1-
15) to black wire on Rocker Switch, as
shown at right.

2. The Rocker Switch assembly (item #2)

will be assembled with the two halves of
the housing already attached. Install the
Mounting Bracket (item #1-2) using (2)
#6 screws (item #1-4) and shake-proof
washers (item #1-7). See figure at right.
Tighten securely. Do not overtighten.

Mounting Hole Pattern:
Two 7/32” holes spaced
4.5” apart

1-2

1-7

1-4