Probuilt Professional Lighting Wobblelight - Manual (Page 5)

5. Reinstall the Wobblelight ® dome / cap assembly by aligning the five mounting holes with the five mounting nuts (note that the dome handle should be aligned with the
power switch).
6. Secure dome with the five mounting screws – do not over tighten.
7. Your assembled Wobblelight
® is now ready for use.
USE OF
Wobblelight ®
By following the safety and operating instructions in this manual, your Wobblelight
® should endure normal abuse and last trouble-free for years.
Step 1: Connect Wobblelight ® to proper electrical power source.
Step 2: Turn switch to “on” position.
Step 3: Place Wobblelight
® in desired location.
ELECTRICAL OPERATION
Your Wobblelight
® is equipped with a 120-volt electrical accessory outlet.
 Per UL 153 and CSA 22.2 No.12 standards for portable lighting, Wobblelight ® has a maximum total service rating of 12 Amps.
 To avoid possible electrical overload, Wobblelight ® should only be plugged into 120-volt, 60-Hz electrical service which is protected by a circuit breaker of 15 amps or less.
 DO NOT overload the Wobblelight ® accessory outlet with power tools and other high-amp devices.
 The accessory outlet on Wobblelight ® is intended for low-amp devices such as radios, fans, and other portable lighting such as Wobblelight ® .
 The following table shows the available amps at the accessory outlet for each Wobblelight ® model, and the corresponding number of like Wobblelight ® units that may be
inter-connected on the same electrical circuit:
Wobblelight ®
model
Max amps on
accessory outlet
# of like units that may
be connected in series
175-watt Metal Halide 10 A 7
400-watt Metal Halide 7 A 3
500-watt Halogen 7 A 2
 Safe electrical operation depends on many factors including the use of extensions cords of the appropriate gauge, type and length.
 Always follow all applicable safety regulations and electrical codes.