Poly-Tex KOOL MART with Roll-up sides - Manual (Page 16)

REV: AD-130315
KOOL MART WITH ROLL-UP SIDES
2"
2"
66"
POLY CURTAIN
TUBE CLIP
MARK FOR
ROLL-UP TUBE
POLY CURTAIN
LENGTH AS
REQUIRED
FIGURE 2
Unroll and position the “roll-up curtain” poly film along each side of the
structure. Be sure to have equal excess film on both ends. For best
results, work from the middle of the structure and move to the ends when
securing the poly. Using the edge of the poly as a guide, raise the poly
into place with about 2” above the rail and secure the poly to the poly
fastener base using wiggle wire provided. Be certain the wiggle wire does
not overlap studs see FIGURE 1 . Tension the poly and maintain a
minimum of 2" of poly excess above the poly fastener base. After the
curtain is hung, using a blunt object, press all wiggle wire firmly into base
to ensure it has been seated properly.
After the poly is secure, measure down 66” from the top rail and place a
series of marks on the poly using a marking pen.
Snap together the roll-up tube for each side. Using the marks to align
each tube, fasten the curtain to the tube with tube clips every 3' per
FIGURE 2 keeping the tube straight.
FIGURE 1
DO NOT OVERLAP
STUDS WITH WIGGLE WIRE
59-1/2"
WIGGLE WIRE
59-1/2"
WIGGLE WIRE
GEARBOX END