Poly-Tex KOOL MART with Roll-up sides User Manual
Page 14
REV: AD-130315
NOTE: IF THIS IS A NEW CONSTRUCTION, SKIP TO PAGE SEVEN
1. After poly has been removed from the roof, remove screws and wiggle wire base from both sides of
structure (FIGURE 1).
2. Place a mark at 55 1/4" from bottom of frame on each hoop (FIGURE 2).
3. Attach 18" wiggle wire base 3 1/4" from end to each corner using 2 #12-14 X 1" self-drilling screws
(FIGURE 3).
4. Cut out 4" of wiggle wire base at each corner frame section at the mark placed in step 2 (FIGURE 4).
5. Attach stud hook and short speed hook at the mark measured in step 2 with the bolt and tab facing
towards the inside of the greenhouse (FIGURE 5).
6. Attach the Roll-up Guide Bracket at each hoop using 2 #12-14 X 1" self-drilling screws (FIGURE 6).
7. Drill 1/2" hole 2" from end at each corner on one end to secure gearbox guides (FIGURE 7).
ROLL-UP GUIDE
BRACKET
#12-14 X 1" SELF
DRILLING SCREW
5/16" x 1 1/4" CARRIAGE
BOLT, LOCK WASHER,
& HEX NUT
STUD HOOK
SHORT SPEED
HOOK
2"
2"
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
55 1/4"
3 1/4"
MARK
2"