Otter Outdoors Wild Bench Seat (For 2036,2026,2046 Wild T600 Packages) - Manual (Page 2)

2. Place the straight support bar on the bench and attach with the tube clamp brackets and
Phillips head machine screws. The bar should overhang the bench by 4” at the rear.
3. At the rear of the sled measure 6 ½”from the lip for the Wild 1, 7 ½” for the Wild 2, or
13” for the Wild 3 and drill a 5/16” hole. Place the hinge bracket on the sled and mark
the second hole and then drill another 5/16” hole.
Attach the bracket using the hex head bolts, washers and nylock nuts. Repeat procedure
at the front of the sled.
7 ½”
Wild 2
7 ½” Wild 2
13”
Wild 3
6 ½”
Wild 1
13” Wild 3
6 ½” Wild 1
4”