Otter Outdoors Wild Bench Seat (For 2036,2026,2046 Wild T600 Packages) - Manual

411 West Congress St., Maple Lake, MN 55358 / 320-963-6480
Bench Instructions
Parts included:
Tools required:
Drill
5/16 drill bit
7/16 wrench or socket and ratchet
10mm socket and ratchet
Phillips screwdriver
1. Layout all parts. Turn bench over so the bottom is facing upward and the hinges are
facing you. Place the curved support bar on the bench and place the tube clamp bracket
over the bar and attach with the Phillips head machine screws by threading them into the
inserts in the bottom of the bench. Attach brackets in two places on the support bar.
Bar should overhang the bench by 4” at the rear. It is not centered on the bench. This is
done to minimize the tipping of the sled due to the front angle on the sled.
Instructions - 70804
4”
Hinge
Tube clamp
bracket
4”