ODL Add-on/DIY Blinds—raised frame sidelights - Manual (Page 2)

DOES IT FIT?
Carefully lift the treatment assembly and place over the window.
The frame should fit snugly over the entire window frame
against the door/sidelight. Look for anything that will prevent a
flush fit or keep the treatment from functioning. Set the
treatment assembly down, standing it upright.
DOOR HARDWARE INTERFERENCE
If you are installing on the door, and your door hardware is
located close to your door glass frame, you could encounter
interference with the fit of your Enclosed Treatment Unit. To
avoid this interference simply remove the filler strip located on
that side of the Enclosed Treatment frame. This will allow the
escutcheon plate on your door hardware to slip underneath
the Enclosed Treatment frame. If the tabs on the frame (used
to hold the filler strip on the frame) are in the way, you can
simply clip them off with pliers.
If you have a lever door handle and the handle extends over your door glass / door glass frame, the
Enclosed Treatment unit may not fit. This interference issue is common with lever arm handles and
window treatments. In order to make the Enclosed Treatment unit fit you will either have to change your
door knob so that it does not extend over the door glass frame, or purchase a lever door handle extender.
ENCLOSED TREATMENT INSTALLATION INSTRUCTIONS
1
1
Thank you for your purchase of ODL enclosed treatments.
Unpack your treatment assembly and check for damage.
Be sure to remove the protective cardboard located on both
sides of the treatment (blind only). Be sure you have the right
unit size for your window by holding the assembly up to the door
window. It is important to operate the treatment only while it is
upright. Be sure to read the instructions prior to beginning actual
installation.
For assistance with enclosed treatment installation or for additional
product information, call ODL customer service toll free at
1.866.ODL.4YOU (635-4968), or visit our website at www.odl.com.
HALF VIEW
VISTA PARCIAL
DEMI-VUE
FULL VIEW
VISTA COMPLETA
PLEINE VUE
Tab-Open/Close
(blind only)
Lengüeta para abrir y cerrar
Taquet ouvert/fermé
Top Brackets
Soportes superiores
Supports du haut
Tab-Raise/Lower
Lengüeta para elevar y bajar
Taquet – Lever/Baisser
Tab-Raise/Lower
Lengüeta para elevar y bajar
Taquet – Lever/Baisser
Top Brackets
Soportes superiores
Supports du haut
Tab-Open/Close
(blind only)
Lengüeta para abrir y cerrar
Taquet ouvert/fermé
Spacer
espaciador
entretoise
Single Top Bracket if needed
(7 x 64 only)
Si fuera necesario coloque un
soporte superior (sólo de 7 x 64)
(17,78 cm x 162,56 cm)
Support unique du haut si
nécessaire (18 cm x 162 cm
[7 po x 64 po] uniquement)
Lock Clip
sujetador de cierre
pince de fermeture
Lock Clip
sujetador de cierre
pince de fermeture
Lock Clip
sujetador de cierre
pince de fermeture
Lock Clip
sujetador de cierre
pince de fermeture