Northstar Trailers MULTISTAR - Manual (Page 6)

STEP 2: WIRE ASSEMBLY
Note: when standing at the back of the trailer looking toward the front, with the trailer still
inverted, the wiring harness bundle with the YELLOW wire will be threaded along the
DRIVER’S side (right side when looking at the trailer upside-down) to the brake/signal light,
and the bundle with the GREEN wire will be threaded along the PASSENGER’S side (left side)
to the brake/signal light.
RUN WIRE
a. Locate the first rib back from the front of the trailer. (The only rib that has an entry
hole and flat bracket). While facing the front of the trailer, push the wiring
harness (12) through the eye in the rib, and run the harness with the yellow wire
inside the rib to your right, and the harness with the green wire to your left.
b. Insert the hollow, round plug into the eye of the rib plate bracket. (This prevents
the wires from rubbing directly against the frame). Leave the plug exposed. (The
plug will connect to tongue’s wire in STEP 5).
c. Pull the wires along the ribs until the wires reach the side of the trailer.
d. Where the wire bundles split, run the green and yellow bundles along their
respective sides of the trailer, along the frame, and back to the tail/brake light
positions, and then run the brown and white wires to the running light position on
each corner of the trailer. Pull the wires through the holes on the sides of the trailer
in preparation for light connection.