NOCO Genius G7200 - Manual (Page 10)

17 16
G7200
geniuschargers.com
USING THE G7200
USER INTERFACE
MODE BUTTON
The MODE button
is used to select
the charging modes
manually.
12V NORM LED
Charge mode for
12V Wet, Gel and MF
batteries.
(14-230Ah)
12V COLD/AGM
LED
Charge mode for
12V batteries below
32°F (0°C) and AGM
batteries.
(14-230Ah)
WICKED SMART FEATURE
ERROR CONDITION. An ERROR condition could happen for multiple
reasons. If an ERROR condition occurs, the ERROR LED and CHARGE
LEDs (25%, 50%, 75%, 100%) will blink “on” and “off” at 5Hz. For
assistance in resolving ERRORs, see the section entitled,
“TROUBLESHOOTING.”
Now That’s Smart, Wicked Smart.™
ERROR LED
The ERROR LED (Orange)
will illuminate when an error
condition or reverse polarity
is present.
24V NORM LED
Charge mode for
24V Wet, Gel and
MF batteries.
(14-120Ah)
13.6V SUPPLY
LED
A 12V charge mode
for maintenance
charging or low
voltage batteries.
(14-230Ah)
24V COLD/AGM
LED
Charge mode for
24V batteries below
32°F (0°C) and AGM
batteries.
(14-120Ah)
16V BOOST LED
A 12V charge mode
for recovering battery
capacity from sulfated
batteries.
(14-230Ah)
CHARGE LEVEL
Indicates the current
charge level of the
battery.
STANDBY LED
The STANDBY LED
(Green) illuminates
when a charging
mode has not been
selected.
WICKED SMART FEATURE
EXTENSION CABLE ACCESSORY. If you have a preferred location,
but the length of the battery connectors is too short, you can use
an Extension Cable to increase the length. A 10’ Extension Cable is
available from NOCO Genius, Model Number GC004. Using an Extension
Cable may increase the battery charge times.
Now That’s Smart, Wicked Smart.™
USING THE G7200