MoJack PRO - Manual (Page 7)

MoJack PRO Lift MoJack PRO Lift
12 13
Operating Instructions
STEP 7
Adjusting Support Rods for Proper Tire Size
• Adjust Support Rods on Wheel Pads to accommodate the front
tire size of the mower. Please refer to the chart below for proper
Support Rod placement based on the diameter of the mower’s
front tires.
• Secure Support Rods to Wheel Pads with Hair Pins.
Support Rod
Hair Pin
See page 19 for more more detailed guide.
10” - 11.5” (25cm - 29cm)
12” - 15” (30cm - 38cm)
15.5” - 17” (39cm - 44cm)
SUPPORT ROD GUIDE FOR TIRE SIZES
STEP 6
Aligning Wheel Pads to Fit the Mower
• Place the front tires of mower 6” in front of
the Wheel Pads.
• Remove Push Pins and align the Wheel
Pads so that the front mower tires will be
centered on the Wheel Pads.
• Replace the Push Pins to lock the Wheel
Pads to the Lift Arm.
Wheel Pads must be equal distance
from the Lift Arm to maintain proper
balance.
STEP 5
Familiarize Yourself with the MoJack PRO
• Practice raising and lowering the Lift Arm before
attempting to lift the mower. (see Steps 9-16 on
how to raise and lower the Lift Arm)
• Practice Step 21 if you intend to raise or lower the
mower with the drill attachment.
STEP 10
Strapping Front Mower Tires to Wheel Pads
• Secure the front mower tires to the Wheel Pads using the
Safety Straps . Secure the hook on the Safety Strap to
the Wheel Pad Cross Bar and insert the Support Rod into
the loop on the Safety Strap by detaching the Support
Rod and then sliding the Safety Strap Loop through and
reattaching the Support Rod.
• Tighten the Safety Straps over the top of the tires to
secure mower to Wheel Pads.
14
Wheel Pad Cross Bar
Support Rod
Safety Strap
Operating Instructions
Using the MoJack PRO (Steps 9 - 16)
STEP 9
Move Mower onto MoJack PRO
The MoJack PRO must be used on a solid
level surface.
• Drive or roll the mower onto the Wheel Pads.
Stop engine and remove the key.
STEP 8
Reverse Front Tires of Mower (optional – if not applicable, skip to Step 9)
• In some cases, the mower deck or anti-scalping wheels will hit the
Lift Arm while the mower is being raised. This is often the case if
part of the deck (including the anti-scalping wheels) protrudes past
the center line of the front wheels of the mower.
• Rotate the front tires 180° so that they are in the reverse position.
• Remove the Support Rods from the Wheel Pads and slide the
MoJack PRO underneath the mower.
• Secure the Support Rods to Wheel Pads with Large Hair Pins.
Reverse
Wheel
Position
Forward
Wheel
Position