Lincoln Electric IM10061 POWER WAVE S350 - Manual (Page 12)

A-5 INSTALLATION
POWER WAVE ® S350
A-5
CONNECTION DIAGRAMS
GTAW (TIG) WELDING
A user interface is required for adjusting the TIG weld-
ing settings. S-series user interface (K3001-2) can be
installed into the power source (Figure A.3). Refer to
the connection diagrams based on the user interface
that is being used. Alternate configurations are possi-
ble depending on the wire feeder that is being used.
Refer to the wire feederʼs manual for alternative config-
urations.
SMAW (STICK) WELDING
Similar to TIG welding a user interface is required for
adjusting the Stick welding settings. A Power Feed
wire feeder can be used as the user interface, or a
K3001-2 (user interface control panel) can be installed
into the power source (Figure A.4). The connection
diagram shown is based on the S-Series user inter-
face (K3001-2). In this diagram the remote control box
is optional.
GMAW (MIG) WELDING
An arclink compatible wire feeder is recommended for
Mig welding. Refer to Figure A.5 for the connection
details.
FIGURE A.3
FIGURE A.4
K3001-2
TIG WITH S-SERIES USER INTERFACE
FOOT AMPTROL
WORK PIECE
WORK CLAMP
TIG TORCH
K1782-1,-3,12
TO POSITIVE
(+) STUD
TO REMOTE CONTROL
RECEPTACLE
USER INTERFACE
CONTROL PANEL
GAS SOLENOID KIT
(INSIDE MACHINE)
K2825-1
TO NEGATIVE
(-) STUD
REGULATOR
FLOWMETER
GAS HOSE K87 870, K870-2 AND 0, K870-2 AND
K2909-1 K2909-1
K960-3
STICK WITH S-SERIES USER INTERFACE
K3001-2
REMOTE CONTROL BOX
K857-2
USER INTERFACE
CONTROL PANEL
TO POSITIVE
(+) STUD
ELECTRODE HOLDER KIT
K875 OR K704
(INCLUDES GROUND CLAMP)
TO NEGATIVE
(-) STUD
WORK PIECE
WORK CLAMP