Lincoln Electric IM10024 MAXsa 22_29 Wire Drive - Manual (Page 25)

C-1 ACCESSORIES C-1
OPTIONS AND ACCESSORIES are
available at www.lincolnelectric.com
Follow these steps:
1. Go to www.lincolnelectric.com
2. In the Search field type E9.181 and click on the
Search icon (or hit ‘Enter’ on the keyboard).
3. On the Results page, scroll down to the
Equipment list and click on E9.181.
All of the information for the Power Wave System
accessories can be found in this document.
K2311-1 Motor Conversion Kit (for 142:1
NA Style Wire Drives)--
This conversion kit con-
verts old NA style wire drives to MAXsa™ 22 & 29
WIRE DRIVES.
1. Remove the 2 hex head screws and the 2 slot head
screws holding the Motor to the Wire Drive Gearbox
assembly.
2. Remove existing Adapter Plate and Motor Assembly.
3. The Conversion Kit Motor is shipped configured for a
142:1 gear ratio. The existing gearbox must be con-
figured for a 142:1 gear ratio for the Conversion Kit to
assemble correctly. If both assemblies are not con-
figured for the same gear ratio, this must be done
before continuing. (See Gear Ratio Conversion Kit
instructions.)
4. Cover the teeth of the new Motor pinion gear with a
non-fluid molydisulfide type grease such as Non-Fluid
Oil Corporation’s A-29 Special/MS Lubricant. This
grease can be scooped from the cavity of the gear
case First Chamber.
5. Reassemble the new Adapter Plate and Motor
Assembly on the Wire Drive Gearbox; making sure
the gears mesh properly and the Adapter Plate locat-
ing bead is in its cavity. Replace and tighten the 4
screws removed in step 1.
MAXsa™ 22 & 29 WIRE DRIVES