AT&T 1040 User Manual

Page 46

One-touch setup and operation

To modify a one-touch number

1. When a one-touch telephone number is

displayed, press

[ ] or [ ] to highlight MODIFY.

2. Press

[ENTER].

3. Press the dial pad keys to enter up to 24 digits.

• You can include a pause while modifying a

dialing sequence which requires one during
actual dialing. Press

[ ] or [ ] until you see

PAUSE, then press [ENTER] when storing a
pause. The screen will display

P. Each pause

counts as one digit. Continue storing the
number as usual.

• Store a signal for switching to temporary

tone dialing, required for some special services,
if you have dial pulse (rotary) service. Press

[ ]

[ ] until you see TONE, then press [ENTER].

T will appear on the screen. All numbers

entered after this will send touch tone signals
during dialing.

• You can store the flash signal required by

some special services as part of a dialing
sequence. Press

[ ] or [ ] until you see FLASH,

then press

[ENTER]. An F will appear on the

screen. Continue storing the number as usual.

• To erase the last digit, scroll to DELETE CHAR

and then press

[ENTER].

-OR-
Press

[REMOVE].

•

To copy the most recently dialed number

from redial, press

[(AUTO) REDIAL]. Only the

last number dialed from this extension can
be copied to a one-touch location. The other
numbers in the redial shack cannot be copied.

•

To cancel programming, scroll to CANCEL and

then press

[ENTER].

continued on next page

VIEW SPD#01
5550100

MODIFY