Lincoln Electric IM10000 Cool-Shield Helmet - Manual (Page 8)

SHADE GUIDE:
If your helmet does not include any one of the shades referenced above, it is
recommended you use the next darker shade.
• DO NOT WELD WITH A DAMAGED OR DEFECTIVE LENS, i.e.
cracked, pitted, etc.
ALWAYS TEST TO BE SURE THE ADF CARTRIDGE IS CHARGED
BEFORE WELDING. The helmet can be placed in sunlight to charge. Do not
store the helmet in a dark cabinet or other storage area for extended periods.
While welding the Arc also charges the ADF cartridge.
5
WARNING
GUIDE FOR SHADE NUMBERS
OPERATION ELECTRODE SIZE ARC MINIMUM SUGGESTED(1)
1/32 in. (mm) CURRENT (A) PROTECTIVE SHADE NO.
SHADE (COMFORT)
Shielded metal arc Less than 3 (2.5) Less than 60 7 –
welding 3-5 (2.5–4) 60-160 8 10
5-8 (4–6.4) 160-250 10 12
More than 8 (6.4) 250-550 11 14
Gas metal arc Less than 60 7 –
welding and flux 60-160 10 11
cored arc welding 160-250 10 12
250-500 10 14
Gas tungsten arc Less than 50 8 10
welding 50-150 8 12
150-500 10 14
Air carbon (Light) Less than 500 10 12
Arc cutting (Heavy) 500-1000 11 14
Plasma arc welding Less than 20 6 6 to 8
20-100 8 10
100-400 10 12
400-800 11 14
Plasma arc cutting (Light)
(2)
(2)
(2) Less than 300 8 9
(Medium) 300-400 9 12
(Heavy) 400-800 10 14
Torch brazing – – 3 or 4
Torch soldering – – 2
Carbon arc welding – – 14
PLATE THICKNESS
in. mm
Gas welding
Light Under 1/8 Under 3.2 4 or 5
Medium 1/8 to 1/2 3.2 to 12.7 5 or 6
Heavy Over 1/2 Over 12.7 6 or 8
Oxygen cutting
Light Under 1 Under 25 3 or 4
Medium 1 to 6 25 to 150 4 or 5
Heavy Over 6 Over 150 5 or 6
(1) As a rule of thumb, start with a shade that is too dark, then go to a lighter shade which gives sufficient view of the weld zone without going
below the minimum. In oxyfuel gas welding or cutting where the torch produces a high yellow light, it is desirable to use a filter lens that absorbs
the yellow or sodium line the visible light of the (spectrum) operation
(2) These values apply where the actual arc is clearly seen. Experience has shown that lighter filters may be used when the arc is hidden by the
workpiece.
.
Data from ANSI Z49.1-2005
LENS REPLACEMENT
Outside Protective Cover Lens Replacement:
Press down on the Tab inside the top of the helmet while also pressing in on
the Finger Tabs on both sides of the bezel piece on the front of the helmet.
Pull the bezel outward to remove. Remove the polycarbonate protective
lens. Place the new polycarbonate lens in the recessed lens area. Be sure
the cover lens is properly seated. Then, simply insert the lower tabs of the
bezel back into the helmet shell and rotate up, snapping the bezel into place.
Ensure all three tabs have been correctly snapped in. Never use the Auto-
Darkening FILTER without the inside and outside cover lens properly
installed.
Lens Removal
6
OUTSIDE
TAB
OUTSIDE
TAB
BEZEL
INSIDE TAB