Lincoln Electric IM10000 Cool-Shield Helmet - Manual (Page 10)

AUTO-DARKENING CARTRIDGE ACCESS AND REPLACEMENT:
Remove the Bezel as described in previous section on Lens Replacement.
After removing the outside lens, simply remove the Adaptor by applying
thumb pressure to top center tab to release top portion of Adaptor. Pull for-
ward and release feet of Adaptor from Shell. Then remove the ADF filter.
When replacing, be sure the light sensors are facing toward the front of the
helmet when replacing the cartridge. Replace the inside cover lens,
Cartridge, Adaptor, outside spatter lens and Bezel in reverse order. The
outer polycarbonate lens is required to protect the ADF from weld spatter and
impacts.
7
INSTALLING AN AFTERMARKET MAGNIFYING LENS:
Simply slide the magnifying lens into the short rails located over the protec-
tive cover lens.
HELMET CARE AND MAINTENANCE:
Virtually maintenance free:
• Periodic cleaning with soapy water solution or standard glass clean-
er is suggested for any ADF to function properly. Use soft cloth or
eye glass wipes.
• This ADF is water resistant. Do “NOT” submerge in water or other
solution.
• Change or clean cover lens when it becomes dirty or cloudy.
Storage:
• Store in a clean dry location.
8