AT&T 900 MHz - Manual (Page 13)

Change Remote Access Code
Change the code you use to access features and functions of the answering
system from a touch tone phone. The Remote Access Code comes set to 500.
NOTE: Do not use the same code as the Priority Calling Code.
1 Press
9 (SETUP) until the system announces “Remote access
code is….”
2 Press
4 (REPEAT) or 6 (SKIP) to change the first digit, then press
9 (SETUP) to move to the next digit. Repeat for second and third
digits.
3 Press
9 (SETUP) when your choice is announced and displayed.
Priority Call Signal
When a caller enters the Priority Calling Code from a touch tone phone,
the system “chirps” to alert you that you have a Priority Call. You’ll need to
provide select callers with the Priority Calling Code (preset to 999) in
order for them to use this feature.
1 Your caller dials your telephone number from a touch tone phone.
2 When the announcement begins to play, your caller can enter the
Priority Calling Code.
3 The system “chirps,” then pauses. This continues for up to 30
seconds, unless you answer the phone, or the system picks up
the call.
4 If you do not answer, your caller can press
5 to stop the Priority
Call signal.
5 The caller can press
1 or 2 to leave a message in Mailbox 1 or
Mailbox 2.
Change Priority Calling Code
Change the code a caller enters to alert you that you have a Priority Call.
The Priority Calling Code comes set to 999.
NOTE: Do not use the same code as the Remote Access Code.
1 Press
9 (SETUP) until the system announces “Priority Calling
Code is….”
2 Press
4 (REPEAT) or 6 (SKIP) to change the first digit, then press
9 (SETUP) to move to the next digit. Repeat for second and third
digits.
3 Press
9 (SETUP) when your choice is announced and displayed.
FEATURE SETUP
12