Feature setup, Caller id feature setup – AT&T 900 MHz User Manual

Page 10

Caller ID Feature Setup

You can set up Caller ID features at the handset right after setting up the
final Telephone feature (Handset Ringer), by programming your Home Area
Code. Otherwise, follow

Steps 1-4 in “Telephone Feature Setup” on page 8

to begin setting up Caller ID features.

Program Home and Local Area Codes

Your “home area code” is usually the area code from which you are dialing.

“Local area codes” are area codes for which you must dial an area code but

not “1.” Always program your home area code, and, if you need them, up to
four local area codes to allow for correct operation of the Display Dial
feature (see page 39).

NOTE: Do not select

CHANGE. Instead, when screen displays

AREA CODE 1:

Use the keypad to enter your home area
code (

AREA CODE 1).

Select

CODE 2 to reach AREA CODE 2 (the

screen displays any current local area code
stored here). Use the keypad to enter a
three-digit local area code.

Continue as in

Step 1 for area codes 3, 4

and 5 as needed.

Select

DONE when finished.

Caller ID with Call Waiting

You must subscribe to Caller ID with Call Waiting
service (a

combined service) in order for this

feature to work. If you don’t have Caller ID with
Call Waiting service, turn this feature off.

Call List Options

Choose whether the system stores information
about

ALL CALLS received, or for NO CALLS.

FEATURE SETUP

AREA CODE 1:000

CODE 2

DONE

LIST:NO CALLS

CHANGE

DONE

LIST:ALL CALLS

CHANGE

DONE

CIDCW: OFF

CHANGE

DONE

CIDCW: ON

CHANGE

DONE