3 arm mounting, Figure 4-25: tighten the in-wall mounting screws – IEI Integration AFL-4 series-N270 v2.11 User Manual

Page 67

AFL-4 Series-N270 User Manual

Page 67

Figure 4-25: Tighten the In-wall Mounting Screws

4.10.3 Arm Mounting

The AFL-4 Series-N270 is VESA (Video Electronics Standards Association) compliant and

can be mounted on an arm with a 75mm or 100mm interface pad. To mount the AFL-4

Series-N270 on an arm, please follow the steps below.

Step 1:

The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.

NOTE:

When purchasing the arm please ensure that it is VESA compliant and that

the arm has a 75 mm interface pad. If the mounting arm is not VESA

compliant it cannot be used to support the AFL-4 Series-N270 flat panel

PC. The AFL-4 Series-N270 also support VESA MIS-D 100.

Step 2:

Once the mounting arm has been firmly attached to the surface, lift the flat panel

PC onto the interface pad of the mounting arm.