IEI Integration IEM-LX v1.00 - Manual (Page 85)

IEM-LX-800 ETX CPU Module
EPP1.9 EPP 1.9 is selected as the EPP standard
EPP1.7 (Default) EPP 1.7 is selected as the EPP standard
ECP Mode Use DMA [3]
Use the ECP Mode Use DMA option to specify the DMA channel the parallel port must
use in the ECP mode. (This option is only available if the ECP mode is selected in the
Parallel Port Mode configuration option).
1 Parallel port uses DMA Channel 1 in the ECP mode
3 (Default) Parallel port uses DMA Channel 3 in the ECP mode
CIR Port Address
Use the CIR Port Address option to enable the CIR port and set the CIR port base
address. The configuration options are listed below.
Disabled (Default)
3F8
2F8
3E8
2E8
xCIR Port IRQ
Use the CIR Port IRQ option to specify an interrupt address for the CIR port. The
configuration options are listed below.
11 (Default)
5
6.6 Power Management Setup
Use the Power Management Setup menu (BIOS Menu 7) to set the BIOS power
management and saving features.
Page 85