IEI Integration PICOe-945GSE - Manual (Page 94)

PICOe-945GSE Half-Size CPU Card
Page 94
HDTV out cable
5.1 channel audio kit
7.1 channel audio kit
5.7.2 5.1 Channel Audio Kit Installation
NOTE:
This is an optional item that must be ordered separately. For further
information please contact the nearest PICOe-945GSE distributor,
reseller or vendor or contact an iEi sales representative directly. Send
any queries to
320H
[email protected] .
The optional 5.1 channel audio kit connects to the 10-pin audio connector on the
PICOe-945GSE. The audio kit consists of three audio jacks. One audio jack, Mic In,
connects to a microphone. The remaining two audio jacks, Line-In and Line-Out, connect
to two speakers. To install the audio kit, please refer to the steps below:
Step 1: Connect the audio kit cable. The audio kit is shipped with a cable that
connects the audio kit to the PICOe-945GSE. Connect the cable to the
connector on the back of the audio kit. Make sure the pins are properly aligned
(i.e. pin 1 connects to pin 1).
Step 2: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 3: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
cable connector. Pin 1 on the audio kit cable connector is indicated with a white
dot. See
813H
Figure 5-10.