IEI Integration PICOe-945GSE - Manual (Page 84)

PICOe-945GSE Half-Size CPU Card
Page 84
Figure 5-2: CF Card Installation
5.5 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three metal
pins and a small metal clip (often protected by a
plastic cover) that slides over the pins to connect
them. To CLOSE/SHORT a jumper means
connecting the pins of the jumper with the plastic
clip and to OPEN a jumper means removing the
plastic clip from a jumper. Figure 5-3: Jumper Locations
Before the PICOe-945GSE is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the PICOe-945GSE are listed
in
829H787H
Table 5-1.