Asus PCI Express x1 Network Interface PEB-G21 - Manual (Page 38)

38 A S U S P E B - G 2 1 U s e r G u i d e A S U S P E B - G 2 1 U s e r G u i d e A S U S P E B - G 2 1 U s e r G u i d e A S U S P E B - G 2 1 U s e r G u i d e A S U S P E B - G 2 1 U s e r G u i d e
Installing the UNIX Driver Software: UnixWare/OpenUnix 8 Installing the UNIX Driver Software: UnixWare/OpenUnix 8 Installing the UNIX Driver Software: UnixWare/OpenUnix 8 Installing the UNIX Driver Software: UnixWare/OpenUnix 8 Installing the UNIX Driver Software: UnixWare/OpenUnix 8
O v e r v i e w O v e r v i e w O v e r v i e w O v e r v i e w O v e r v i e w
This procedure describes the installation procedure for the UnixWare driver. The
driver is released as an installable package in datastream format.
Installing the Driver Installing the Driver Installing the Driver Installing the Driver Installing the Driver
1. Do the following to install the bcme package on the Unixware system:
pkgadd -d .
Where is the full path name of the installable package bcme-
.pkg.
2. After the package is installed, use netcfg or scoadmin network to add the new
network adapter.
3. When prompted, select the Line Speed and then select Advanced Option for
Flow Control, MAC Address , and Jumbo MTU Size settings, if desired. The
settings for these properties are listed below:
Line Speed
• Auto-Negotiate (default) (all speeds advertised)