ADIC FastStor Mass Storage Device - Manual (Page 57)

Troubleshooting and Diagnostics 41
❐ Press the SELECT button to begin the drive head cleaning process. The LCD will display the following blinking message:
Ct 2 (Sel)
2 3 4 5 6 7
❐ If necessary, place a cleaning tape in slot 2 then press SELECT. FastStor will move the cleaning tape to the drive and
cleaning will begin. During cleaning the following message will be displayed on the LCD, and the Activity Bars will indicate
the drive activity.
Cleaning 2
2 3 4 5 6 7
Notes
If you press SELECT before placing the cleaning cartridge in slot 2, FastStor will continue to display the above message.
If a data cartridge is in slot 2 and you press SELECT, FastStor will treat it like a cleaning cartridge and move it to the
drive.
If a cartridge is in the drive when you press SELECT, a dRIVE FULL error will be posted. Clear the error by pressing the
MODE button. Use the EJECT dRV mode to remove the cartridge from the drive, then start the cleaning process again.
When the cleaning process is complete, the drive will automatically eject the cartridge, and FastStor will place it back in slot
2. The following blinking message will then be displayed on the LCD:
RMV 2 (Sel)
2 3 4 5 6 7
❐ Remove the cleaning cartridge from slot 2, then press the SELECT button to return FastStor to LdR REAdY.