ADIC FastStor Mass Storage Device - Manual (Page 42)

26 Operation and Maintenance
Mode 4 – EJECT PCKR
Mode 4 causes the FastStor to eject a tape left in the Media Picker at power down to any empty destination slot.
Notes
A tape will normally not be left in the Picker at power down.
Executing EJECT PCKR Mode when the Media Picker does not have a tape will result in PCKR EMPTY and a large E
(indicating an error condition) appearing on the LCD for approximately 25 seconds. If this occurs, you may press the
Mode button to return the FastStor the LdR REAdY before the 25 seconds elapses.
❐ To access Mode 4, press the MODE button until the LCD appears as shown:
eject pckr
2 3 4 5 6 7
❐ Press the SELECT button to select Mode 4. The LCD will appear as shown while the drive ejects the tape (N is the slot the
FastStor will attempt to move the tape to.):
st slot n
2 3 4 5 6 7
❐ Use the NEXT or PREVIOUS button to scroll through the destination slot choices. Press SELECT when the slot you wish to
place the tape in is displayed. When your FastStor has completed the command, it will return to LdR REAdY.
Note
If the destination slot is full, a blinking RESELECT will appear on the LCD. The blinking RESELECT indicates that you attempted
to select an invalid destination slot.