Information, Proper care – White’s Electronics MXT 300 User Manual
Page 32
32
Proper care
I. Cleaning
A. Both the coil and rod are waterproof and can
be cleaned with fresh water and mild soap. The
control box is not water proof and must be kept
dry. Never lift a wet coil above the height of
the control box as water can run down the
inside of the rod damaging the electronics. A
damp cotton cloth can be used to wipe off a
dirty control box.
II. Weather
A. Do not expose your detector to the condi-
tions of a car trunk during winter and/or sum-
mer extremes.
B. Protect it from direct sunlight during storage.
C. The control box is rain resistant. However, it
must be protected from heavy rain.
III. Storage
A. When the instrument is not in use, make sure
it is turned OFF.
B. If you plan on storing your detector for
long, remove the battery holder from the in
strument and remove the batteries from the
holder.
C. Store the instrument indoors, in an area
where it will be protected from abuse. Over the
years Whiteʼs has noted more service repairs
and physical damage, on units in storage than
those experiencing daily use.
IV. Additional Precautions
A. Avoid dropping your detector while attempt
ing to set it down to dig.
B. Avoid using your detector for leverage when
standing up from a dig.
C. Do not use any lubricants, such as WD-40,
on any part of your detector.
D. Do not modify your instrument during its
warranty period.
32
32
Chapter 7 MXT 300 Information
Information
1.White's Electronics
1011 Pleasant Valley Rd.
Sweet Home, OR 97386
(541) 367 6121
Fax (541) 367 6629
2. Electronic Exploration
575 West Harrison
Lombard, IL 60148
(800) 392-3223
(630) 620-0618
(630) 620-1005 FAX
3. Centreville Electronics
10063 Wellington Rd.
Manassas, Va. 20110
(888) 645-0202
(703) 367-7999
(703) 367-0868 FAX
Whiteʼs reputation has been built on quality
products backed by quality service. Our Factory
Authorized Service Centers are factory trained and
equipped. They offer the same quality service as
the factory. Service before and after the sale is the
cornerstone of our customer relations.
A. Contact your Dealer. There may be a
quick, simple fi x or explanation that will prevent
having to send the detector in for service.
B. Double check the obvious, such as batteries,
and try the detector in another area to be sure there
isn't interference.
C. Be sure to send all necessary parts with your
detector, such as batteries and holders, as these
items can result in symptoms.
D. Always include a letter of explanation about
your concerns, even if you have talked to the Ser-
vice Center by telephone.
E. Take care in packaging instruments for ship-
ping. Always insure your package.
Before shipping
detectors for service
White's Authorized Service
Centers