Argus Camera DC1510 - Manual (Page 5)

Top panel
Powering Up
Battery Installation
1. Slide the compartment cover at the bottom of your camera. See Figure 1.
2. Install 3-AAA alkaline batteries into the battery compartment. See Figure 2.
3. Make sure the battery polarities are oriented exactly as shown. See Figure 2.
4. Close battery compartment cover.
Figure 1 Figure 2
CAUTION - To avoid battery leakage
• Non-rechargeable batteries are not to be recharged
• Be sure to insert batteries in correct orientation
• Remove batteries from the camera before extended storage
• Always remove old or dead batteries from the camera
• Do not short-circuit the power supply terminals
• Check that the contact surfaces are clean and bright before installing batteries
Battery Power Levels
If at anytime the frame counter information begins to flash in the LCD panel, the battery level is
low. Download your photos to the computer and replace the batteries immediately.
Turning camera on / off
Press Mode button to power on the camera. Two short beeps will sound. (High Resolution) will
appear momentarily before (frame counter) is shown on the LCD panel, indicating that a maximum
of 20 photos can be taken with high resolution.
To power off the camera, press Mode button repeatedly until "oF" displays on the LCD panel. Then
press Shutter button.
Auto Off
The camera will automatically turn off in 30 seconds if no operation has been performed.
4
USB cable connector
Shutter button