Anetsberger Brothers MG - Manual (Page 6)

6
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION REQ TION REQ TION REQ TION REQ TION REQUIREMENTS UIREMENTS UIREMENTS UIREMENTS UIREMENTS
!
GAS CONNECTION INSTRUCTIONS GAS CONNECTION INSTRUCTIONS GAS CONNECTION INSTRUCTIONS GAS CONNECTION INSTRUCTIONS GAS CONNECTION INSTRUCTIONS
I
nstall the grill in accordance with the preceding Code Requirements, as well as the following Installation
Requirements.
1. DO NOT install this grill in a mobile home, trailer, or recreational vehicle.
2. Install this grill in a location that allows it to be moved away from other adjacent appliances for cleaning
and maintenance.
NOTE: If the grill is installed among a row of appliances, with its only convenient movement forward,
sufficient room must be available in front of the grill to permit its separation from adjacent appliances
for cleaning and maintenance.
3. Confirm that the air from the ventilation hood flowing near the grill after installation is NOT blowing on
the rear of the unit, to prevent affecting the burner flames and possibly causing damage to plastic parts.
CAUTION: Hood make-up air MUST NOT flow in a manner that restricts or
impedes the natural flow of combustion or ventilation air.
Installing your
ANETS Grill requires the following procedure:
1. Ensure that all the gas control valve knobs on the grill are turned to the “OFF” position.
2. Ensure that the gas supply inlet line valve is closed (handle crosswise to the line direction).
3. Connect the ¾” gas supply line to the gas line regulator in the rear of the grill.
4. Open the gas supply line valve (handle in-line with line direction); then, confirm that all gas supply
joints and couplings are free of leaks using soap suds or a leak-check solution, after the grill is in
its desired location.
5. Refer to Grill Operating Instructions to begin using your
ANETS Grill.
WARNING WARNING WARNING WARNING WARNING
DO NOT use a flame to check for leaks.
!