Anetsberger Brothers MG - Manual (Page 12)

12
GRILL GRILL GRILL GRILL GRILL TR TR TR TR TROUBLESHOO OUBLESHOO OUBLESHOO OUBLESHOO OUBLESHOOTING GUIDE TING GUIDE TING GUIDE TING GUIDE TING GUIDE
(Continued)
PROBLEM CAUSE REMEDY
Grill plate is not hot
enough.
1. Check that thermostat control
setting is at desired setting.
2. Check gas supply pressure with all
other equipment operating. (6”
WC for natural gas and 11” WC
for propane, minimum).
3. Check for fans or excessive air
flow over grill surface.
4. Check for dirty/sooty pilot burner.
5. Observe if grill plate temperature
is acceptable.
1. Yes – Proceed to test #2.
No – Increase setting. Skip to
test #5.
2. Above – Proceed to test #3.
Below – Increase gas supply
pressure. Skip to test #5.
3. Yes – Block or turn off air supply.
Skip to test #5.
No –P proceed to test #4.
4. Yes – Clean pilot burner.
Proceed to test #5.
No – proceed to test #5.
5. Yes – Okay.
No – Replace thermostat.
Black soot accumu-
lation on burners on
under side of grill
plate. 1. Check if pressure regulator is
installed in supply line.
2. Adjust pressure regulator setting by
turning the adjusting slot counter-
clockwise (under the slotted cap).
1. Yes – Proceed to test #2
No – Install regulator supplied
with unit. Proceed to test #2.
5. Check gas supply pressure with all
other equipment operating. (6”
WC for natural gas and 11” WC
for propane, minimum).
6. Observe if main burners are firing.
5. Increase if needed, proceed to
test #6.
6. Yes - Okay.
No - Replace thermostat.
(Continued)
Grill plate is cold
(Burners not
firing).