Warner Electric MCS-805 User Manual
Page 2
2
Warner Electric • 800-234-3369
P-239-31
Failure to follow these
instructions may result in product damage,
equipment damage, and serious or fatal
injury to personnel.
Contents
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . back cover
Introduction
Warner Electric’s MCS-805-1 and MCS-805-2
series clutch/brake controls are designed for
operation with Warner Electric electrically
released brakes. The correct brake release volt-
age is a specific point between 35-75VDC. This
point is set by adjusting the control at the time
of brake installation. These controls are factory
set for 60 volts output.
The MCS-805-1 and MCS-805-2 controls oper-
ate from 120/230VAC single phase input power.
Switching may be provided on either the AC or
DC side of the control.
The MCS-805-1 and the MCS-805-2 have an
internal adjustment potentiometer that is use for
the release band adjustment. The MCS 805-2 is
similar to the MCS-805-1 except that it has
torque adjustment capability for soft stop appli-
cations. The MCS 805-2 requires two switching
circuits when used for those applications requir-
ing soft engagement.