Warner Electric CBC-300 - Manual (Page 2)

2 Warner Electric • 800-825-9050 P-269-2 • 819-0410
Failure to follow these instructions may result
in product damage, equipment damage, and serious or fatal
injury to personnel.
Part Numbers
6011-101-001 5K ohm remote accessory potentiometer, 1 turn for level adjust on
CBC-300-2, CBC-300-C2, CBC-300-3, and CBC-300-C3.
6011-101-002 10k ohmΩ remote accessory potentiometer 1 turn for current adjust on CBC-300-1,
CBC-300-C1, CBC-300-3, and CBC-300-C3.
Specifications
6011-101-001 5k ohm, potentiometer, 2 watts, 10% tol. single turn, bushing mounted
6011-101-002 10 k ohm potentiometer, 2 watts, 10% tol. single turn, bushing mounted
Cable Length
10 ft. 22 GTAWY, 3 conductor with shield,
60º C rating.
Mounting
Panel mounted via 3/8 – 32 bushing on
potentiometer
General
The remote accessory potentiometer provide for
remote operation of specific CBC-300 controls,
combination of one or both potentiometers allow
for adjustment of the output current or level
applied to clutch or brake. The 5k potentiometer
allows for level adjustment of both output’s
between zero and maximum level. The 10k
potentiometer is used for adjusting the current
output.
Mounting and Installation
Select a location where the potentiometer is to be
mounted. This should be such that it is within the
allowable cable length supplied.)
Note: It is not recommended to splice the cable
for longer wiring runs. If the cable length is not
sufficient, then either mount the control closer to
the potentiometer or relocate the potentiometer
closer to the control.
Figure 1