WARN ZEON 10-S Multi-Mount User Manual

Page 3

987960A0

I N S T A L L A T I O N I N S T R U C T I O N S

NOTE: This unit is to be used only on vehicles equipped with a Warn Front Receiver or a class 3 receiver trailer hitch.

1. Install the fairlead on the front of the winch mounting plate (Figure 1.)

FIGURE 1

2. Install the winch to the mounting plate using the instructions and fasteners provided with the winch.

NOTE: Start all bolts into the winch feet before tightening. The winch feet may spread during shipping. Start both bolts in one

drum support then hold free end of the winch up off of the mounting plate while starting the bolts. DO NOT DRILL THE

MOUNTING HOLES LARGER. The winch will be properly aligned once all bolts are tightened.

3. The 6-foot electrical quick-connect cable furnished is intended for connection to the battery on vehicle front receiver installations.

For winch use at the rear of vehicle, longer quick-connect cables are available from Warn dealers. For 20-foot kit, order part

number 32963. For 24- foot kit, order part number 32966. Choose a location on the bumper or grille to mount the quick-connect

plug as shown in Figure 2. Be sure that the plug from the winch will reach when the multi-mount is inserted in the receiver with

hitch pin in place. Connect the + and - cable ends to the vehicle battery.

CHEMICAL AND FIRE HAZARD

Failure to observe these instructions could lead to severe injury or death.

• Always inspect the quick connect polarity on the cable from the battery AND the cable from the winch.

• Always inspect the quick connect polarity on the cable from the battery AND the cable from the winch, before connecting the cables to the battery. Make sure the positive (+) cable

exits the side of the plug marked with a “+” symbol, and the negative (-) ground cable exits the side of the plug marked with a “-” symbol. The positive cable can be identified by

the white stripe and the “+” symbols printed on the insulation. Some positive cables have red insulation. The ground cable is black.

Read installation and operating instructions thoroughly.

W A R N I N G

7/16” x 1 1/4”

Bolt

Multi-Mount Frame

Hawse Fairlead

7/16” Nut

7/16” Washer