Actiontec electronic GT701A - Manual (Page 39)

36
Actiontec USB/Ethernet DSL Modem User Manual
37
Chapter 4 Using Advanced Setup
4. In the next screen, read the recommendations. To perform an advanced setup
on the Modem, click Begin Advanced Setup.
5. The “Configuring the Advanced Settings” screen appears. To check all the set-
tings, or if unsure of which settings to modify, select Next. To modify a spe-
cific configuration, click on its name in the menu bar on the left.
☞
Note: To save changes made in any of the Advanced Setup
screens, click Save and Restart at the bottom of the gray menu
on the left side of the screen.
WAN IP Address
Selecting WAN IP Address in the “Configuring the Advanced Settings” screen gen-
erates the “ WAN IP Address” screen. WAN IP Address allows manual set up of the
IP address of the Modem. There are five ways to do this: Transparent Bridging,
Obtain an
IP Address through PPP o E , Obtain an IP Address Through PPPoA ,
Obtain an IP Address through DHCP , and Specify a Static IP Address.
☞
Note: If unsure about which connection is present, check with
the Internet Service Provider ( ISP) before continuing.