Teledyne LeCroy Spectrum Analyzer - Manual (Page 8)

Spectrum Analyzer Software
6 921324 Rev A
Circular markers appear over the trace, representing the x peak amplitude
measurements.
5. Choose to Sort By amplitude or frequency on the measurements table.
The table is reordered to show the marker with highest amplitude or frequency value on
top. The marker number assignment does not change.
6. Optionally, reposition the trace by choosing a peak to Set Center Freq. to. Select the
desired marker from the table or enter the marker number in Peak #. Touch Apply.
The trace shifts, and the new x peak amplitudes in that span of frequencies are marked
and tabulated.
Tip: If you do not want the peaks to be renumbered after changing the center frequency,
use the Markers feature instead and choose to Set Markers on Peaks.
7. To maximize the grid area, uncheck Show Table. To remove the frequency readout from
the markers, uncheck Show Freq.