Teledyne LeCroy TF-HDMI-3.3V - Manual (Page 3)

ա p
TF-HDMI-3.3V – 50 ohms Pull-up Terminator
SDA-LNES Quick Reference Guide Rev A
3
INTRODUCTION TO TF-HDMI-3.3V
HDMI Compliance test requires signals to be terminated with a 50 ohms pull-up to 3.3V when using direct cable
measure.
The TF-HDMI-3.3V provides such a termination while transmitted the signal to the oscilloscope input. It is
designed for full HDMI bandwidth so that the signal is integrally transmitted.
TF-HDMI-3.3V is compatible with all oscilloscopes with ProLink Input and software version 5.6.x.x or higher.
Specifications
Interface ProLink
Input Connector Type
(SIG, TERM) SMA (f)
Output Connector
Type BMA (m), ProLink
Input Coupling 50 Ω - DC
Input Impedance 50 Ω
Output Source
Impedance 50 Ω
Non-Destruct Input
Range 1.5 V min to 3.5 V max
DC Gain into 50 Ω 0.20 +/- 1.5%
AC Gain -14 dB +/- 0.5 dB
-14 dB +/- 1 dB 0 < frequency < 2 GHz
2 GHz < frequency < 10 GHz
Input Return Loss > 20 dB
> 15 dB
> 10 dB frequency <= 2 GHz
2 GHz < frequency <= 8 GHz
8 GHz < frequency <= 10 GHz
S22 > 6 dB
Risetime (10-90%) < 35 ps
Overshoot < 5% 20 ps risetime input