Teledyne LeCroy JTA2 - Manual (Page 22)

JTA2 Option
20
ISSUED: December 2003 JTA2-OM-E Rev A
CHOOSING A TIMING PARAMETER
This table lists the Jitter and Timing Analysis (JTA) parameters and the tasks that they can
perform. Additional analysis and processing of the waveform can be carried out by activating
Statistics and using histogram parameters. For some parameters, one of the variants of
JitterTrack can perform the same task.
If You Want To Use This Timing
Parameter
For Further
Processing Or JitterTrack
measure accuracy of
clock, period or
frequency p@lv
freq@lv
Statistics On or use
Histogram Period Jitter
Frequency Jitter
measure pulse width
accuracy wid@lv Statistics On or use
Histogram Width Jitter
measure adjacent cycle
deviation Dp@lv Statistics On or use
Histogram Cycle-to-Cycle Jitter
count number of edges
in a waveform edge@lv --- ---
measure duty cycle duty@lv Statistics On or use
Histogram Duty Cycle Jitter
measure time interval
error tie@lv Statistics On or use
Histogram Interval Error Jitter
measure n-cycle n-cycle@lv --- N-Cycle Jitter
measure skew skew --- Clock Skew
measure setup setup --- Setup
measure hold hold --- Hold